HONDA TRX450R Frame Skid Plate Installation Instructions
Preparation: a) Lock rear parking brake on quad, turn gas petcock to Off and stand quad upright on the rear grab bar. Make sure vehicle is secure and will not fall over while installing your new skid...
View ArticleHonda/Acura Traction System Installation Instructions
This system is a bolt-on package that is designed to enhance traction by eliminating wheel hop and promoting weight transfer to the front wheels. Installation of this product requires the permanent...
View ArticleHonda 300EX Frame Skid Plate H937022 Installation Instructions
Preparation: a) Set/Lock rear parking brake, turn gas petcock to the Off position and stand bike upright so it is sitting on the rear grab bar. Ensure bike is stable to prevent falling over during...
View ArticleK20A/A2/Z1 A/C and P/S Removal Kit Installation Instructions
This kit provides the SOLUTION for eliminating air conditioning and power steering on motors found in the 02-06 RSX, ITR and CTR while: -Relocating the alternator to avoid headlight material removal on...
View Article2003-2005 Hummer HII Edelbrock Lower Trailing Arms Installation Instructions
1. Raise vehicle and support with jackstands on a stable surface. Note: Vehicle must be supported with vehicle’s normal weight on rear axle. Do not support vehicle by its trailing arms. 2. Remove only...
View Article2001-2009 Chevy 2500HD 2&4wd G.M. Heavy Duty Outer Tie Rod System Instructions
INSTALLATION INSTRUCTIONS 1. Disconnect the negative terminal on the battery. Jack up the front end of the truck and support the frame rails with jack stands. Remove the front tires. NEVER WORK UNDER...
View ArticleHummer H2 Powerstep Installation Instructions
Step One REMOVE CANISTER PURGE VALVE BRACKET AND ROCK RAIL Remove the Canister Purge Valve Bracket from the Rock Rail. Set the bolt aside to be reused later. Then remove the ten bolts that secure the...
View Article2005-Up KIA Sportage / Hyundai Tucson Receiver Hitch Installation Instructions
1. Check all parts. Read and understand instructions completely before beginning installation. Clean the under side of the frame. Clean out the weld nuts in the frame. Parts List: 1) Hitch 6) 10mm –...
View ArticleTransmission, Knocking Noise Under Load Technical Bulletin
Knocking noises at load change from pendulum support. Tip: If vehicle is equipped with 6 speed manual transmission (MQ350), see Technical bulletin Instance number 2015981 in ElsaWeb. Technical...
View ArticleCan someone give me info on how to change a valve cover gasket for a ‘02...
Problem: Can someone link me to a DIY how-to or give me the info itself on how to replace a leaking valve cover gasket for a ‘02 Toyota Camry V6? As well as any torque specs for the valve cover bolts....
View Article
